|
|
 |
Retainer Wire Installation Video in Pilot Drills Bits
|
|
Retention Wire Installation in Pilot Drill Bits
- First take the supplied pilot drill and the supplied retaining wire and insert the wire into the first hole closest to the tip.
- Insert the wire so that there is 3/8” sticking out then bend down the non-cut side of the wire.
- Cut the wire so there is 3/8” of wire sticking out on either side.
- Always bend the wire toward the flutes, away from the tip of the pilot drill.
- Always only bend the wire so that it is sticking out past the OD of the pilot drill.
- Repeat steps 2-5 using the supplied pilot drill and the supplied retaining wire, when inserting the wire into the second hole.
|
|
|
